21x Pilot Slow Jet Kit for MIKUNI VM/TM/TMX VM22/210 AX100 EN GN TZR TMS Carburetor Jet Kit 15-65

Bought these jets for a VM-36 on my XT500. The sizes were accurate and legibly written on the jets. The brass also seemed to be a higher quality than the OEM Mikuni jet. Users will notice the hole at the top of the jet is smaller than what an OEM 35 pilot would have regardless of size; ignore this, the sizes are still accurate.

They work well in my nibbi carburetors

Works great for the VM Mikunis

The media could not be loaded. Used on my son's PW80 with original Mikuni. I removed the oil pump, cut the exhaust funnel out and put a cone filter on instead of housing. Bike starts perfect now the original pilot was way too big had to know it down to a 20. Bike runs like a champ now

These will not fit my vm22 carburetor. I will have to sand the beveled edge of the nozzle in order for it to go down into the port. Also the the pilot jets are much shorter. Not sure if that will effect them but I can't install them anyway. If I have time I will report the size of the pilot jets with a micromete

The work well. However be warned that they don't match the Mikuni numbering. #30 Mikuni pilot jet is not the same as this seller's #30. I wasted a lot of time because of this. Other than the minor issue, they work really well and allows you to tune your bike.

They fit nicely, but different sizes than actual Mikuni. All the jets were drlled none missed in manufacturing. Mikuni number 15 is around a 30 or bigger in these jets. You look and listen to your engine anyways not a number so.. but does take it a little longer to figure out.

Stamped with size. Fit and work great. Super variety of sizes. A+